OK folks I’m sorry but the only people who were even looking at this were people I knew already – the idea of bringing lots of new people in by updating content daily failed. I’m no longer hoping to complete a year of daily photos because of that and also because I couldn’t always find […]
Archive | Flute 365 Project
RSS feed for this sectionFlute 365 Day 57 – New bird design…
This bird design was inspired by ones I’ve seen from other makers all over… I rather like it.
Flute 365 Day 56 – Bore Walls
When using the lathe, you can make the walls THIN…
Flute 365 Day 55 – Maple Two
Further progress being made on the maple flute – Work on the lathe is now done.
Flute 365 Day 54 – Precision Chiselling
Sometimes you have to use a chisel to cut the ramp and flue… and you have to be ACCURATE.
Flute 365 – Day 53 – Workshop Thermometer
Errrr – NOPE.
Flute 365 Day 52 – Maple
Well today I’ve been shaping a new Maple flute – and came up with a new idea for detail.
Flute 365 – Day 51 – Splitsville!
So… here we go again after a seven day hiatus due to my day job! Sadly it’s with bad news about the branch flute… 🙁
Flute 365 – Day 50 – Planning a Branch Flute…
There’s a privet bush at the end of our drive which regularly needs trimming… today I took this off – and decided to make a flute with it. It’s going to be a while drying – the ends are capped with beeswax.
Flute 365 – Day 49 – New stock enters the world…
The new flute I posted about the other day goes out into the world for sale…